công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

X1243S8I bảng dữ liệu(PDF) 5 Page - Xicor Inc.

tên linh kiện X1243S8I
Giải thích chi tiết về linh kiện  Real Time Clock/Calendar/Alarm with EEPROM
Download  18 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  XICOR [Xicor Inc.]
Trang chủ  http://www.xicor.com
Logo XICOR - Xicor Inc.

X1243S8I bảng dữ liệu(HTML) 5 Page - Xicor Inc.

  X1243S8I Datasheet HTML 1Page - Xicor Inc. X1243S8I Datasheet HTML 2Page - Xicor Inc. X1243S8I Datasheet HTML 3Page - Xicor Inc. X1243S8I Datasheet HTML 4Page - Xicor Inc. X1243S8I Datasheet HTML 5Page - Xicor Inc. X1243S8I Datasheet HTML 6Page - Xicor Inc. X1243S8I Datasheet HTML 7Page - Xicor Inc. X1243S8I Datasheet HTML 8Page - Xicor Inc. X1243S8I Datasheet HTML 9Page - Xicor Inc. Next Button
Zoom Inzoom in Zoom Outzoom out
 5 / 18 page
background image
X1243
5
value to a specific day of the week is arbitrary and may
be decided by the system software designer. The Clock
Default values define 0=Sunday.
Clock/Calendar Registers (YR, MO, DT, HR, MN, SC)
These registers depict BCD representations of the time.
As such, SC (Seconds) and MN (Minutes) range from
00 to 59, HR (Hour) is 1 to 12 with an AM or PM indica-
tor (H21 bit) or 0 to 23 (with T24=1), DT (Date) is 1 to
31, MO (Month) is 1 to 12, YR (year) is 0 to 99.
24 Hour Time
If the T24 bit of the HR register is 1, the RTC will use a
24-hour format. If the T24 bit is 0, the RTC will use 12-
hour format and bit H21 will function as an AM/PM indi-
cator with a ‘1’ representing PM. The clock defaults to
Standard Time with H21=0.
Leap Years
Leap years add the day February 29 and are defined as
those years that are divisible by 4. Years divisible by
100 are not leap years, unless they are also divisible by
400. This means that the year 2000 is a leap year, the
year 2100 is not. The X1243 does not correct for the
leap year in the year 2100.
STATUS REGISTER (SR)
The Status Register is located in the RTC area at
address 003FH. This is a volatile register only and is
used to control the WEL and RWEL write enable
latches, read an optional Low Voltage Sense bit, and
read the two alarm bits. This register is logically seper-
ated from both the array and the Clock/Control Regis-
ters (CCR).
Table 2. Status Register (SR)
BAT: Battery Supply—Volatile
This bit set to “1” indicates that the device is operating
from VBACK, not VCC. It is a read only bit and is set/
reset by hardware.
AL1, AL0: Alarm bits—Volatile
These bits announce if either alarm 1 or alarm 2 match
the real time clock. If there is a match, the respective bit
is set to ‘1’. The falling edge of the last data bit in a SR
Read operation resets the flags. Note: Only the AL bits
that are set when an SR read starts will be reset. An
alarm bit that is set by an alarm occuring during an SR
read operation will remain set after the read operation
is complete.
RWEL: Register Write Enable Latch—Volatile
This bit is a volatile latch that powers up in the LOW
(disabled) state. The RWEL bit must be set to “1” prior
to any writes to the Clock/Control Registers. Writes to
RWEL bit do not cause a nonvolatile write cycle, so the
device is ready for the next operation immediately after
the stop condition. A write to the CCR requires both the
RWEL and WEL bits to be set in a specific sequence.
WEL: Write Enable Latch—Volatile
The WEL bit controls the access to the CCR and mem-
ory array during a write operation. This bit is a volatile
latch that powers up in the LOW (disabled) state. While
the WEL bit is LOW, writes to the CCR or any array
address will be ignored (no acknowledge will be issued
after the Data Byte). The WEL bit is set by writing a “1”
to the WEL bit and zeroes to the other bits of the Status
Register. Once set, WEL remains set until either reset
to 0 (by writing a “0” to the WEL bit and zeroes to the
other bits of the Status Register) or until the part pow-
ers up again. Writes to WEL bit do not cause a non-vol-
atile write cycle, so the device is ready for the next
operation immediately after the stop condition.
RTCF: Real Time Clock Fail Bit—Volatile
This bit is set to a ‘1’ after a total power failure. This is a
read only bit that is set by hardware when the device
powers up after having lost all power to the device. The
bit is set regardless of whether VCC or VBACK is applied
first. The loss of one or the other supplies does not
result in setting the RTCF bit. The first valid write to the
RTC (writing one byte is sufficient) resets the RTCF bit
to ‘0’.
Unused Bits:
These devices do not use bits 3 or 4, but must have a
zero in these bit positions. The Data Byte output during
a SR read will contain zeros in these bit locations.
Addr
7
6
5
4
3
2
1
0
003Fh
BAT
AL1
AL0
0
0
RWEL
WEL
RTCF
Default
0
0
0
0
0
0
0
0


Số phần tương tự - X1243S8I

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Intersil Corporation
X1243S8I INTERSIL-X1243S8I Datasheet
293Kb / 17P
   Real Time Clock/Calendar/Alarm with EEPROM
More results

Mô tả tương tự - X1243S8I

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Intersil Corporation
X1243 INTERSIL-X1243 Datasheet
293Kb / 17P
   Real Time Clock/Calendar/Alarm with EEPROM
ISL12027 INTERSIL-ISL12027_10 Datasheet
390Kb / 28P
   Real Time Clock/Calendar with EEPROM
logo
Xicor Inc.
X1240 XICOR-X1240 Datasheet
74Kb / 19P
   Real Time Clock/Calendar with EEPROM
logo
Intersil Corporation
ISL12027 INTERSIL-ISL12027 Datasheet
414Kb / 28P
   Real Time Clock/Calendar with EEPROM
logo
Renesas Technology Corp
ISL12027 RENESAS-ISL12027 Datasheet
1Mb / 29P
   Real Time Clock/Calendar with EEPROM
logo
Intersil Corporation
ISL12026 INTERSIL-ISL12026 Datasheet
381Kb / 24P
   Real Time Clock/Calendar with EEPROM
ISL12029 INTERSIL-ISL12029 Datasheet
426Kb / 28P
   Real Time Clock/Calendar with EEPROM
logo
Xicor Inc.
X1226 XICOR-X1226 Datasheet
420Kb / 24P
   Real Time Clock/Calendar with EEPROM
logo
Intersil Corporation
ISL12028 INTERSIL-ISL12028 Datasheet
423Kb / 28P
   Real Time Clock/Calendar with EEPROM
X1226 INTERSIL-X1226_06 Datasheet
372Kb / 25P
   Real Time Clock/Calendar with EEPROM
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18


bảng dữ liệu tải về

Go To PDF Page


Link URL




Chính sách bảo mật
ALLDATASHEET.VN
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com