công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
STM8AL3xE8x bảng dữ liệu(PDF) 8 Page - STMicroelectronics |
|
STM8AL3xE8x bảng dữ liệu(HTML) 8 Page - STMicroelectronics |
8 / 18 page Silicon limitations STM8AL3xxx STM8L052R8 STM8L1xxx6/8 8/18 DocID17922 Rev 6 Case 2: It is recommended to avoid any interrupts before WFE mode is entered. This can be done by disabling all interrupts before the device enters Wait for event mode. SIM WFE RIM This workaround also prevents WFE re-execution in case 1. No fix is planned for this limitation. 1.1.5 Core kept in stall mode when DMA transfer occurs during program/ erase operation to EEPROM Description When the MCU performs EEPROM program/erase operation, the core is stalled during data transfer to the memory controller, which occurs at the beginning of the program/erase operation. If a DMA request servicing starts while the core is stalled, the core does not return from stall mode to program execution. The core is stalled for 11 cycles during byte program/erase, 8 cycles during word program/erase and 3 cycles during each word transfer in block programming mode. For block erase, the core is stalled for 127 cycles. When a DMA request arises, it is only served if the DMA priority is higher than the core access priority. If the current DMA priority is lower than the core one, the DMA service is delayed until the core access becomes idle. The DMA also includes a programmable timeout function, configurable by DMA_GCSR register. If the core does not release the bus during this timeout, the DMA automatically increases its own priority and forces the core to release the bus for DMA service. No fix is planned for this limitation. Several workarounds are available for this limitation. Workaround 1 Disable all DMA requests during data transfer to the EEPROM. This workaround is applicable for all program/erase operations. Workaround 2 Configure DMA programmable timeout in the DMA_GCSR register to exceed the number of stall cycles required during the transfer. DMA priority must never be configured to a very high level. This workaround is applicable for all program/erase operations except block erase. In order to apply this workaround to block erase, use block programming to 0x00 instead of block erase. This takes ~6 ms instead of ~3 ms. |
Số phần tương tự - STM8AL3xE8x |
|
Mô tả tương tự - STM8AL3xE8x |
|
|
Link URL |
Chính sách bảo mật |
ALLDATASHEET.VN |
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |