SS1344

Unipolar Hall Switch-Low Sensitivity

5

3.10

Nov 1, 2013

Application Information

It is strongly recommended that an external bypass capacitor be connected (in close proximity to the Hall sensor)

ated by the chopper stabilization technique. As is shown in the following

figure, a 0.1μF capacitor is typical.

For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the V

When using a resistor, three points are important:

- the resistor has to limit the reverse current to 50mA maximum (V

- the resulting device supply voltage V

- the resistor has to withstand the power dissipated in reverse voltage condition (P

2

/R1)

When using a diode, a reverse current cannot flow and the voltage drop is almost constant (

≈0.7V).

Therefore, a 100

Ω/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.

Typical Three-Wire Application Circuit

When a weak power supply is used or when the device is intended to be used in noisy environment, it is

recommended that following figure is used.

Automotive and Severe Environment Protection Circuit

The low-pass filter formed by R1 and C1 and the Zener diode Z1 bypass the disturbances or voltage spikes

occurring on the device supply voltage V

Both solutions provide the required reverse voltage protection.

ESD Precautions

Electronic semiconductor products are sensitive to Electro Static Discharge (ESD).

Always observe Electro Static Discharge control procedures whenever handling semiconductor products.

SS1344

SS1344