công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

ADXL316WBCSZ-RL7 bảng dữ liệu(PDF) 11 Page - Analog Devices

tên linh kiện ADXL316WBCSZ-RL7
Giải thích chi tiết về linh kiện  Small, Low Power, 3-Axis plus minus16 g Accelerometer
Download  14 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  AD [Analog Devices]
Trang chủ  http://www.analog.com
Logo AD - Analog Devices

ADXL316WBCSZ-RL7 bảng dữ liệu(HTML) 11 Page - Analog Devices

Back Button ADXL316WBCSZ-RL7 Datasheet HTML 6Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 7Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 8Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 9Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 10Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 11Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 12Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 13Page - Analog Devices ADXL316WBCSZ-RL7 Datasheet HTML 14Page - Analog Devices  
Zoom Inzoom in Zoom Outzoom out
 11 / 14 page
background image
Data Sheet
ADXL316
Rev. 0 | Page 11 of 14
APPLICATIONS INFORMATION
POWER SUPPLY DECOUPLING
For most applications, a single 0.1 µF capacitor, CDC, placed
close to the ADXL316 supply pins adequately decouples the
accelerometer from noise on the power supply. However, in
applications where noise is present at the 50 kHz internal clock
frequency (or any harmonic thereof), additional care in power
supply bypassing is required because this noise can cause errors
in acceleration measurement. If additional decoupling is needed,
a 100 Ω (or smaller) resistor or a ferrite bead can be inserted in
the supply line. Additionally, a larger bulk bypass capacitor
(1 µF or greater) can be added in parallel to CDC. Ensure that
the connection from the ADXL316 ground to the power supply
ground is low impedance, because noise transmitted through
ground has a similar effect as noise transmitted through VS.
SETTING THE BANDWIDTH USING CX, CY, AND CZ
The ADXL316 has provisions for band-limiting the XOUT, YOUT,
and ZOUT pins. Capacitors must be added at these pins to
implement low-pass filtering for antialiasing and noise
reduction. The equation for the −3 dB bandwidth is
f−3dB = 1/(2π(32 kΩ) × C(X,Y, Z))
or more simply
f–3dB = 5 µF/C(X,Y, Z)
The tolerance of the internal resistor (RFILT) can vary by as much
as ±15% of its nominal value (32 kΩ), and the bandwidth varies
accordingly. A minimum capacitance of 0.0047 µF for CX, CY,
and CZ is recommended in all cases.
Table 4. Filter Capacitor Selection, CX, CY, and CZ
Bandwidth (Hz)
Capacitor (µF)
1
4.7
10
0.47
50
0.10
100
0.05
200
0.027
500
0.01
SELF TEST
The ST pin controls the self test feature. When this pin is connected
to VS, an electrostatic force is exerted on the accelerometer beam.
The resulting movement of the beam allows the user to test if
the accelerometer is functional. The typical change in output is
−0.88 g (corresponding to −50 mV) on the x-axis, 0.88 g (or
+50 mV) on the y-axis, and 1.58 g (or +90 mV) on the z-axis.
The ST pin may be left open circuit or connected to the common
pin (COM) in normal use.
Never expose the ST pin to voltages greater than VS + 0.3 V. If
this cannot be guaranteed due to the system design (for instance,
if there are multiple supply voltages), a low VF clamping diode
between ST and VS is recommended.
DESIGN TRADE-OFFS FOR SELECTING FILTER
CHARACTERISTICS: THE NOISE/BW TRADE-OFF
The selected accelerometer bandwidth ultimately determines
the measurement resolution (the smallest detectable acceleration).
Filtering can lower the noise floor to improve the resolution of
the accelerometer. Resolution is dependent on the analog filter
bandwidth at XOUT, YOUT, and ZOUT.
The output of the ADXL316 has a typical bandwidth of greater
than 500 Hz. The user must filter the signal at this point to limit
aliasing errors. The analog bandwidth must be no more than
half the analog-to-digital sampling frequency to minimize
aliasing. The analog bandwidth can decrease further to reduce
noise and improve resolution.
The ADXL316 has white Gaussian noise, which contributes
equally at all frequencies and is described in terms of µg/√Hz
(the noise is proportional to the square root of the accelerometer
bandwidth). Limit bandwidth to the lowest frequency needed
by the application to maximize the resolution and dynamic
range of the accelerometer.
With the single-pole roll-off characteristic, the typical rms noise
of the ADXL316 is determined by
)
1.6
(
×
×
=
BW
Density
Noise
Noise
RMS
Often, the peak value of the noise is desired. Statistical methods
can only estimate peak-to-peak noise. Table 5 is useful for
estimating the probabilities of exceeding various peak values,
given the rms value.
Table 5. Estimation of Peak-to-Peak Noise
Peak-to-Peak Value
% of Time that Noise Exceeds
Nominal Peak-to-Peak Value
2 × rms
32
4 × rms
4.6
6 × rms
0.27
8 × rms
0.006


Số phần tương tự - ADXL316WBCSZ-RL7

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Analog Devices
ADXL311 AD-ADXL311 Datasheet
419Kb / 12P
   Low Cost, Ultracompact 짹2 g Dual-Axis Accelerometer
REV. A
ADXL311JE AD-ADXL311JE Datasheet
419Kb / 12P
   Low Cost, Ultracompact 짹2 g Dual-Axis Accelerometer
REV. A
ADXL311JE-REEL AD-ADXL311JE-REEL Datasheet
419Kb / 12P
   Low Cost, Ultracompact 짹2 g Dual-Axis Accelerometer
REV. A
ADXL311 AD-ADXL311_15 Datasheet
662Kb / 12P
   Ultracompact 2g Dual-Axis Accelerometer
ADXL312 AD-ADXL312 Datasheet
434Kb / 32P
   3-Axis, 짹1.5 g/짹3 g/짹6 g/짹12 g Digital Accelerometer
REV. 0
More results

Mô tả tương tự - ADXL316WBCSZ-RL7

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Analog Devices
ADXL377BCPZ-RL7 AD-ADXL377BCPZ-RL7 Datasheet
261Kb / 12P
   Small, Low Power, 3-Axis 200 g Accelerometer
REV. 0
ADXL335 AD-ADXL335_10 Datasheet
430Kb / 16P
   Small, Low Power, 3-Axis 짹3 g Accelerometer
REV. B
ADXL335 AD-ADXL335 Datasheet
130Kb / 11P
   Small, Low Power, 3-Axis 짹3 g Accelerometer
Rev. PrA
ADXL327 AD-ADXL327 Datasheet
330Kb / 16P
   Small, Low Power, 3-Axis 짹2 g Accelerometer
REV. 0
ADXL325 AD-ADXL325 Datasheet
309Kb / 16P
   Small, Low Power, 3-Axis 짹5 g Accelerometer
REV. 0
ADXL326 AD-ADXL326 Datasheet
308Kb / 16P
   Small, Low Power, 3-Axis 짹16 g Accelerometer
REV. 0
ADXL377BCPZ-RL7 AD-ADXL377BCPZ-RL7 Datasheet
261Kb / 12P
   Small, Low Power, 3-Axis 200 g Accelerometer
Rev. 0
ADXL330 AD-ADXL330_15 Datasheet
490Kb / 16P
   Small, Low Power, 3-Axis 3 g iMEMS Accelerometer
ADXL323 AD-ADXL323_15 Datasheet
461Kb / 16P
   Small, Low Power, 2-Axis 3 g iMEMS Accelerometer
logo
NXP Semiconductors
FXLS8967AF NXP-FXLS8967AF Datasheet
1Mb / 98P
   3-Axis Low-g Accelerometer
Rev. 1-27 April 2021
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14


bảng dữ liệu tải về

Go To PDF Page


Link URL




Chính sách bảo mật
ALLDATASHEET.VN
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com