công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
TS19378 bảng dữ liệu(PDF) 5 Page - Taiwan Semiconductor Company, Ltd |
|
TS19378 bảng dữ liệu(HTML) 5 Page - Taiwan Semiconductor Company, Ltd |
5 / 7 page TS19378 Taiwan Semiconductor Document Number: DS_P0000199 5 Version: B15 APPLICATION INFORMATION (CONTINUE) EN/SS This pin can be supplied shutdown or soft start function. It is inside pull high function. For normal application, the pin must be connected a capacitor to ground. There is a 5μA current to charge this capacitor, vary the different capacitor value to control soft start time. Allow the switching regulator circuit to be shutdown pulling this pin below a 0.8V threshold voltage; the shutdown supply current is approximately 150μA Inductor Selection For most designs, the different frequency can be reducing the inductor value; The TS19378 is suggested 33μH. Where is inductor Ripple Current. Large value inductors lower ripple current and small value inductors result in high ripple currents. Choose inductor ripple current approximately 20% of the maximum load current 2A, ΔIL=0.4A. The DC current rating of the inductor should be at least equal to the maximum load current plus half the ripple current to prevent core saturation (2A+0.2A). Input Capacitor Selection This capacitor should be located close to the IC using short leads and the voltage rating should be approximately 1.5 times the maximum input voltage. The RMS current rating requirement for the input capacitor of a buck regulator is approximately 1⁄2 the DC load current. A low ESR input capacitor sized for maximum RMS current must be used. A 220µF low ESR capacitor for most applications is sufficient. Over Voltage Protection The OVP voltage is set by outside resistance (R1 and R4). The external resistor sets the OVP voltage according to the following equation: ) 1 4 1 ( ) ( R R V OVP V OVP OUT + × = If VOVP >0.85V, The OVP is happened that to disable the driver until VOVP <0.85V. Output Capacitor Selection For lower output voltage ripple and more stable LED current, higher value output capacitor and low ESR is recommended. A 470µF electrolytic capacitor works for most of the applications. |
Số phần tương tự - TS19378_15 |
|
Mô tả tương tự - TS19378_15 |
|
|
Link URL |
Chính sách bảo mật |
ALLDATASHEET.VN |
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |