công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
TS331CX5RFG bảng dữ liệu(PDF) 2 Page - Taiwan Semiconductor Company, Ltd |
|
TS331CX5RFG bảng dữ liệu(HTML) 2 Page - Taiwan Semiconductor Company, Ltd |
2 / 5 page TS331 Low Power Low Offset Voltage Comparators 2/5 Version: B14 Electrical Characteristics (VCC=5V, TA=25oC; unless otherwise specified.) Characteristics Symbol Min Typ Max Unit Input Offset Voltage (note 3) VIO -- 2 5 mV Input Offset Current, IIN(+) - IIN(-), VCM=0V IIO -- -- 50 nA Input Offset Current (note 4), IIN(+) - IIN(-), VCM=0V IIB -- -- 250 nA Input Common Mode Voltage Range, Vcc=30V VICR -0 -- VCC-1.5 V Voltage Gain, RL ≥15K, Vcc=15V, Vo=1V~11V AVOL 50 200 -- V/mV Large Signal Response Time Vin=TTL Logic Swing. Vref = 1.4V, VRL=5V. RL=5.1KΩ -- -- 300 -- nS Response Time (note 6), VRL=5V. RL=5.1KΩ tTLH -- 1.3 -- uS Output Sink Current, VIN(-)=1V, VIN(+)=0V, Vo≤1.5V ISINK 6.0 16 -- mA Output Saturation Voltage, VIN(-)=1V, VIN(+)=0V, ISINK≤4mA VOL -- 250 400 mV Output Leakage Current, VIN(-)=0V, VIN(+)=1V, Vo=5V IOL -- 0.1 -- nA Supply Current RL = ∞, VCC =5V RL = ∞, VCC =36V Icc -- -- 0.4 1.0 1.0 2.5 mA Note 1. The max. Output current may be as high as 20mA, independent of the magnitude of VCC, output short circuits to VCC can cause excessive heating and eventual destruction. Note 2. This magnitude of input current will only occur if the input leads are driven more negative than ground or the negative supply voltage. This is due to the input PNP collector base junction becoming forward biased acting as an input clamp diode. There is also a lateral PNP parasitic transistor action on the IC chip. This phenomena can cause the output voltage of the comparators to go to the VCC voltage level (or ground if overdrive is large) during the time the input is driven negative. This will not destroy the device and normal output states will recover when the inputs become -0.3V of ground or negative supply. Note 3. At output switch point, VO=1.4Vdc, RS=0Ω with VCC from 5Vdc to 30Vdc, and over the full input common- mode Note 4. Due to the PNP transistor inputs, bias current will flow out of the inputs, this current is essentially constant independent of the output state, therefore, no loading changes will exist on the input lines. Note 5. Input common mode of either input should not be permitted to go more than 0.3V negative of ground or minus supply. The upper limit of common mode range is VCC - 1.5V but either or both inputs can betaken to as high as 30volts without damage. Note 6. Response time is specified with a 100mV step and 5.0mV of overdrive. With larger magnitudes of overdrive faster response times are obtainable. Application information This comparator feature high gain, wide bandwidth characteristics. This gives the device oscillation tendencies if the outputs are capacitive coupled to the inputs via stray capacitance. This oscillation manifests itself during output transitions (VOL to VOH). To alleviate this situation input resistors<10KΩ should be used. The addition of positive feedback (<10 mV) is also recommended. It is good design practice to ground all unused pins. Differential input voltages may be larger than supply voltage without damaging the comparator's inputs. Voltages more negative than -0.3V should not be used. |
Số phần tương tự - TS331CX5RFG |
|
Mô tả tương tự - TS331CX5RFG |
|
|
Link URL |
Chính sách bảo mật |
ALLDATASHEET.VN |
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |