AD7687

Data Sheet

PIN CONFIGURATIONS AND FUNCTION DESCRIPTIONS

REF

1

VDD

2

IN+

3

IN–

4

GND

5

VIO

10

SDI

9

SCK

8

SDO

7

CNV

6

AD7687

TOP VIEW

(Not to Scale)

Figure 5. 10-Lead MSOP Pin Configuration

1

REF

2

VDD

3

IN+

4

IN–

5

GND

10 VIO

9 SDI

8 SCK

7 SDO

6 CNV

NOTES

1. FOR THE LFCSP PACKAGE ONLY,

THE EXPOSED PADDLE MUST BE

CONNECTED TO GND.

TOP VIEW

(Not to Scale)

AD7687

Figure 6. 10-Lead LFCSP Pin Configuration

Table 8. Pin Function Descriptions

Pin No.

Mnemonic

Type1

Function

1

REF

AI

Reference Input Voltage. The REF range is from 0.5 V to VDD. It is referred to the GND pin. This pin should

be decoupled closely to the pin with a 10 µF capacitor.

2

VDD

P

Power Supply.

3

IN+

AI

Differential Positive Analog Input.

4

IN−

AI

Differential Negative Analog Input.

5

GND

P

Power Supply Ground.

6

CNV

DI

Convert Input. This input has multiple functions. On its leading edge, it initiates the conversions and

selects the interface mode, chain or CS. In CS mode, it enables the SDO pin when low. In chain mode, the

data should be read when CNV is high.

7

SDO

DO

Serial Data Output. The conversion result is output on this pin. It is synchronized to SCK.

8

SCK

DI

Serial Data Clock Input. When the part is selected, the conversion result is shifted out by this clock.

9

SDI

DI

Serial Data Input. This input provides multiple features. It selects the interface mode of the ADC as follows:

Chain mode is selected if SDI is low during the CNV rising edge. In this mode, SDI is used as a data input to

daisy chain the conversion results of two or more ADCs onto a single SDO line. The digital data level on SDI

is output on SDO with a delay of 16 SCK cycles.

CS mode is selected if SDI is high during the CNV rising edge. In this mode, either SDI or CNV can enable

the serial output signals when low, and if SDI or CNV is low when the conversion is complete, the BUSY

indicator feature is enabled.

10

VIO

P

Input/Output Interface Digital Power. Nominally at the same supply as the host interface (1.8 V, 2.5 V, 3 V,

or 5 V).

EPAD

N/A

For the LFCSP package only, the exposed paddle must be connected to GND.

1

AI = Analog Input, DI = Digital Input, DO = Digital Output, P = Power, and N/A = not applicable.

Rev. C | Page 8 of 28