công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
NZQFN28 bảng dữ liệu(PDF) 2 Page - Roithner LaserTechnik GmbH |
|
NZQFN28 bảng dữ liệu(HTML) 2 Page - Roithner LaserTechnik GmbH |
2 / 20 page iC-NZ FAIL-SAFE LASER DIODE DRIVER Rev B2, Page 2/20 DESCRIPTION Three-channel laser diode pulse regulator iC-NZ en- ables the continuous wave operation of laser diodes and spike-free switching with defined current pulses in a frequency range of up to 155 MHz. The three channels can be accumulatively pulsed via inputs LENL, LENM and LENH. The peak optical power of the laser diodes is regulated separately for high, mid- dle and low levels and adjusted using the three exter- nal resistors RMH, RMM and RML. The iC is activated via pin EN which triggers a self- test of the device. The system is enabled if no errors are detected. Any errors are signaled at pin NERR. The (average) current monitor can be set using ex- ternal resistor RSI. Overcurrent is signalled at NERR, causing the iC to be shut down. To ensure that the selected laser class is maintained a second monitor input SMD (safety monitor diode) is needed. This optional photo diode monitors the laser power. Exceeding the monitor window, set-up by RSMD, triggers a permanent reset. This is re- ported at output NERR and can be deleted when the system is restarted at EN. For high pulse frequencies the device can be switched into controlled burst mode at input REGEN. A previously settled operating point is maintained throughout the burst phase. When the iC is switched on all safety-relevant sig- nals pertinent to the current monitor, SMD and con- trol unit are checked. These units are in turn mon- itored for the following: overcurrent, short circuits, open pins and whether the laser is switched off in terms of output power. With the exception of the lat- ter these checks are carried out intermittently dur- ing operation. So that the device is single-failure- proof various safety check routines are also imple- mented. To this end a second SMD (safety monitor diode) monitoring the laser power is required. The laser power must stay within a defined range during operation (thus maintaining the laser class). If this range is left, the system is shut down and an error message is generated. |
Số phần tương tự - NZQFN28 |
|
Mô tả tương tự - NZQFN28 |
|
|
Link URL |
Chính sách bảo mật |
ALLDATASHEET.VN |
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |