ADM7160AUJZ-3.3-R7 datasheet(4/24 Pages) AD

tên linh kiện	ADM7160AUJZ-3.3-R7

Giải thích chi tiết về linh kiện	Ultralow Noise, 200 mA Linear Regulator

Download	24 Pages

Scroll/Zoom	100%

nhà sản xuất	AD [Analog Devices]

Trang chủ	http://www.analog.com

Logo

4 / 24 page

ADM7160

Data Sheet

Rev. 0 | Page 4 of 24

Parameter

Symbol

Test Conditions/Comments

Min

Typ

Max

Unit

POWER SUPPLY REJECTION RATIO

PSRR

ILOAD = 100 mA

VIN = VOUT + 0.5 V

100 kHz, VIN = 3.8 V, VOUT = 3.3 V

49

dB

500 kHz, VIN = 3.8 V, VOUT = 3.3 V

43

dB

1 MHz, VIN = 3.8 V, VOUT = 3.3 V

43

dB

100 kHz, VIN = 3.0 V, VOUT = 2.5 V

46

dB

500 kHz, VIN = 3.0 V, VOUT = 2.5 V

44

dB

1 MHz, VIN = 3.0 V, VOUT = 2.5 V

44

dB

VIN = VOUT + 1 V

100 kHz, VIN = 4.3 V, VOUT = 3.3 V

54

dB

500 kHz, VIN = 4.3 V, VOUT = 3.3 V

46

dB

1 MHz, VIN = 4.3 V, VOUT = 3.3 V

46

dB

100 kHz, VIN = 3.5 V, VOUT = 2.5 V

49

dB

500 kHz, VIN = 3.5 V, VOUT = 2.5 V

47

dB

1 MHz, VIN = 3.5 V, VOUT = 2.5 V

47

dB

1

Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This specification applies only to

output voltages greater than 2.2 V.

2

Start-up time is defined as the time from the rising edge of EN to when VOUT is at 90% of its nominal value.

3

Current-limit threshold is defined as the current at which the output voltage falls to 90% of the specified typical value. For example, the current limit for a 3.0 V output

voltage is defined as the current that causes the output voltage to fall to 90% of 3.0 V (that is, 2.7 V).

INPUT AND OUTPUT CAPACITORS, RECOMMENDED SPECIFICATIONS

TA = −40°C to +125°C.

Table 2.

Parameter

Symbol

Min

Typ

Max

Unit

Minimum Input and Output Capacitance1

CMIN

0.7

µF

Capacitor ESR

RESR

0.001

0.2

Ω

1

The minimum input and output capacitance should be greater than 0.7 μF over the full range of operating conditions. The full range of operating conditions in the

application must be considered during device selection to ensure that the minimum capacitance specification is met. X7R and X5R type capacitors are recommended;

Y5V and Z5U capacitors are not recommended for use with any LDO regulator. For more information, see the Input and Output Capacitor Properties section.

Số phần tương tự - ADM7160AUJZ-3.3-R7

nhà sản xuất	tên linh kiện	bảng dữ liệu	Giải thích chi tiết về linh kiện
Analog Devices	ADM7160	840Kb / 23P	High PSRR, RF Linear Regulator
	ADM7160	1Mb / 24P	High PSRR, RF Linear Regulator
	ADM7160	1,022Kb / 23P	High PSRR, RF Linear Regulator
	ADM7160	1Mb / 47P	20V, 200mA, Ultra-Low Noise, Ultra-High PSRR, Linear Regulator 19-101798; Rev 0; 10/23

More results

Mô tả tương tự - ADM7160AUJZ-3.3-R7

nhà sản xuất	tên linh kiện	bảng dữ liệu	Giải thích chi tiết về linh kiện
Analog Devices	ADP151	540Kb / 24P	Ultralow Noise,200 mA, CMOS Linear Regulator REV. 0
	ADP151_VD	574Kb / 24P	Ultralow Noise, 200 mA, CMOS Linear Regulator REV. D
	ADP151CB-3.3-EVALZ	561Kb / 24P	Ultralow Noise, 200 mA, CMOS Linear Regulator Rev. E
Texas Instruments	LP5907	1Mb / 36P	[Old version datasheet] Ultralow-Noise, 250-mA Linear Regulator
Analog Devices	ADP150	620Kb / 20P	Ultralow Noise, 150 mA CMOS Linear Regulator REV. 0
	ADP150_VA	580Kb / 20P	Ultralow Noise, 150 mA CMOS Linear Regulator REV. A
	ADP150	603Kb / 20P	Ultralow Noise, 150 mA CMOS Linear Regulator REV. B
Texas Instruments	TPS799	1Mb / 41P	[Old version datasheet] 200-mA, Low-Quiescent Current, Ultralow Noise, High-PSRR Low-Dropout Linear Regulator
Analog Devices	ADM7150	801Kb / 24P	800 mA Ultralow Noise, High PSRR, RF Linear Regulator Rev. 0
Analog Devices	ADM7154	782Kb / 23P	600 mA, Ultralow Noise, High PSRR, RF Linear Regulator Rev. B

More results

ADM7160AUJZ-3.3-R7 bảng dữ liệu(PDF) 4 Page - Analog Devices

ADM7160AUJZ-3.3-R7 bảng dữ liệu(HTML) 4 Page - Analog Devices

Số phần tương tự - ADM7160AUJZ-3.3-R7

Mô tả tương tự - ADM7160AUJZ-3.3-R7

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

bảng dữ liệu tải về

Link URL