30

DIP Connectors

The CW Dual-In-Line Plug (DIP) connector is used for rapid, permanent connection

of ribbon cable to a PC board or to a standard DIP socket when connect/disconnect

capabilities are required. The cover is factory preassembled to the connector base to

simplify assembly to cable and has ridges for cable alignment. CW DIP connectors

are Mil-DTL-83503/6 approved.

on cover and base

at pin #1 provides orientation and

contact identification.

Cable fits snugly between base’s

cover-support posts, and is guided

into position by ridges molded into

inner surface of cover.

required. Factory preassembled

cover minimizes assembly time.

Cable is inserted and terminated in

one simple step.

No exposure

of unnecessary sections of the

contact and possible shorting at the

PC board interface.

are strong,

yet flexible enough to withstand

occasional bending and

straightening without fatigue.