công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

AD5175BCPZ-10-RL7 bảng dữ liệu(PDF) 4 Page - Analog Devices

tên linh kiện AD5175BCPZ-10-RL7
Giải thích chi tiết về linh kiện  Single-Channel, 1024-Position, Digital Rheostat with I2C Interface and 50-TP Memory
Download  20 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  AD [Analog Devices]
Trang chủ  http://www.analog.com
Logo AD - Analog Devices

AD5175BCPZ-10-RL7 bảng dữ liệu(HTML) 4 Page - Analog Devices

  AD5175BCPZ-10-RL7 Datasheet HTML 1Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 2Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 3Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 4Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 5Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 6Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 7Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 8Page - Analog Devices AD5175BCPZ-10-RL7 Datasheet HTML 9Page - Analog Devices Next Button
Zoom Inzoom in Zoom Outzoom out
 4 / 20 page
background image
AD5175
Rev. 0 | Page 4 of 20
Parameter
Symbol
Test Conditions/Comments
Min
Typ1
Max
Unit
DYNAMIC CHARACTERISTICS4, 10
Bandwidth
−3 dB, RAW = 5 kΩ, Terminal W, see Figure 23
700
kHz
Total Harmonic Distortion
VA = 1 V rms, f = 1 kHz, RAW = 5 kΩ
−90
dB
Resistor Noise Density
RWB = 5 kΩ, TA = 25°C, f = 10 kHz
13
nV/√Hz
1 Typical specifications represent average readings at 25°C, VDD = 5 V, and VSS = 0 V.
2 Resistor position nonlinearity error (R-INL) is the deviation from the ideal value measured between the maximum resistance and the minimum resistance wiper
positions. R-DNL measures the relative step change from ideal between successive tap positions.
3 The maximum current in each code is defined by IAW = (VDD − 1)/RAW.
4 Guaranteed by design and not subject to production test.
5 See Figure 8 for more details.
6 Resistor Terminal A and Resistor Terminal W have no limitations on polarity with respect to each other. Dual-supply operation enables ground referenced bipolar
signal adjustment.
7 Different from operating current; the supply current for the fuse program lasts approximately 55 ms.
8 Different from operating current; the supply current for the fuse read lasts approximately 500 ns.
9 PDISS is calculated from (IDD × VDD) + (ISS × VSS).
10 All dynamic characteristics use VDD = +2.5 V, VSS = −2.5 V.
INTERFACE TIMING SPECIFICATIONS
VDD = 2.7 V to 5.5 V; all specifications TMIN to TMAX, unless otherwise noted.
Table 2.
Limit at TMIN, TMAX
Parameter
Conditions1
Min
Max
Unit
Description
fSCL2
Standard mode
100
kHz
Serial clock frequency
Fast mode
400
kHz
Serial clock frequency
t1
Standard mode
4
μs
tHIGH, SCL high time
Fast mode
0.6
μs
tHIGH, SCL high time
t2
Standard mode
4.7
μs
tLOW, SCL low time
Fast mode
1.3
μs
tLOW, SCL low time
t3
Standard mode
250
ns
tSU;DAT, data setup time
Fast mode
100
ns
tSU;DAT, data setup time
t4
Standard mode
0
3.45
μs
tHD;DAT, data hold time
Fast mode
0
0.9
μs
tHD;DAT, data hold time
t5
Standard mode
4.7
μs
tSU;STA, set-up time for a repeated start condition
Fast mode
0.6
μs
tSU;STA, set-up time for a repeated start condition
t6
Standard mode
4
μs
tHD;STA, hold time (repeated) start condition
Fast mode
0.6
μs
tHD;STA, hold time (repeated) start condition
High speed mode
160
ns
tHD;STA, hold time (repeated) start condition
t7
Standard mode
4.7
μs
tBUF, bus free time between a stop and a start condition
Fast mode
1.3
μs
tBUF, bus free time between a stop and a start condition
t8
Standard mode
4
μs
tSU;STO, setup time for a stop condition
Fast mode
0.6
μs
tSU;STO, setup time for a stop condition
t9
Standard mode
1000
ns
tRDA, rise time of the SDA signal
Fast mode
300
ns
tRDA, rise time of the SDA signal
t10
Standard mode
300
ns
tFDA, fall time of the SDA signal
Fast mode
300
ns
tFDA, fall time of the SDA signal
t11
Standard mode
1000
ns
tRCL, rise time of the SCL signal
Fast mode
300
ns
tRCL, rise time of the SCL signal
t11A
Standard mode
1000
ns
tRCL1, rise time of the SCL signal after a repeated start condition
and after an acknowledge bit
Fast mode
300
ns
tRCL1, rise time of the SCL signal after a repeated start condition
and after an acknowledge bit
t12
Standard mode
300
ns
tFCL, fall time of the SCL signal
Fast mode
300
ns
tFCL, fall time of the SCL signal
t13
RESET pulse time
20
ns
Minimum RESET low time
tSP3
Fast mode
0
50
ns
Pulse width of the spike is suppressed
tEXEC4, 5
500
ns
Command execute time


Số phần tương tự - AD5175BCPZ-10-RL7

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Analog Devices
AD517 AD-AD517 Datasheet
312Kb / 6P
   Low Cost, Laser Trimmed, Precision IC Op Amp
REV. A
AD5170 AD-AD5170 Datasheet
900Kb / 24P
   256-Position Two-Time Programmable I2C Digital Potentiometer
REV. A
AD5170BRM10 AD-AD5170BRM10 Datasheet
900Kb / 24P
   256-Position Two-Time Programmable I2C Digital Potentiometer
REV. A
AD5170BRM10-RL7 AD-AD5170BRM10-RL7 Datasheet
900Kb / 24P
   256-Position Two-Time Programmable I2C Digital Potentiometer
REV. A
AD5170BRM100 AD-AD5170BRM100 Datasheet
900Kb / 24P
   256-Position Two-Time Programmable I2C Digital Potentiometer
REV. A
More results

Mô tả tương tự - AD5175BCPZ-10-RL7

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
Analog Devices
AD5174 AD-AD5174 Datasheet
1,009Kb / 20P
   Single-Channel, 1024-Position, Digital Rheostat with SPI Interface and 50-TP Memory
REV. 0
AD5272BRMZ-20 AD-AD5272BRMZ-20 Datasheet
713Kb / 28P
   1024-/256-Position, 1% Resistor Tolerance Error, I2C Interface and 50-TP Memory Digital Rheostat
REV. D
AD5272 AD-AD5272 Datasheet
720Kb / 28P
   1024-/256-Position, 1% Resistor Tolerance Error, I2C Interface and 50-TP Memory Digital Rheostat
REV. D
AD5270 AD-AD5270 Datasheet
725Kb / 24P
   1024-/256-Position, 1% Resistor Tolerance Error, SPI Interface and 50-TP Memory Digital Rheostat
Rev. F
AD5231 AD-AD5231 Datasheet
562Kb / 24P
   Nonvolatile Memory, 1024-Position Digital Potentiometers
REV. 0
AD5231 AD-AD5231_15 Datasheet
536Kb / 28P
   Nonvolatile Memory, 1024-Position Digital Potentiometer
REV. D
AD5235 AD-AD5235 Datasheet
102Kb / 10P
   Nonvolatile Memory, Dual 1024 Position Digital Potentiometers
REV PrD 6 Nov 2000
ADN2850 AD-ADN2850_16 Datasheet
749Kb / 30P
   Nonvolatile Memory, Dual 1024-Position Digital Resistor
AD5235 AD-AD5235_15 Datasheet
788Kb / 32P
   Nonvolatile Memory, Dual 1024-Position Digital Potentiometer
Rev. F
ADN2850 AD-ADN2850_15 Datasheet
604Kb / 28P
   Nonvolatile Memory, Dual 1024-Position Digital Resistor
Rev. E
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20


bảng dữ liệu tải về

Go To PDF Page


Link URL




Chính sách bảo mật
ALLDATASHEET.VN
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com