công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

MC14497 bảng dữ liệu(PDF) 3 Page - Motorola, Inc

tên linh kiện MC14497
Giải thích chi tiết về linh kiện  PCM REMOTE CONTROL TRANSMITTER
Download  8 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  MOTOROLA [Motorola, Inc]
Trang chủ  http://www.freescale.com
Logo MOTOROLA - Motorola, Inc

MC14497 bảng dữ liệu(HTML) 3 Page - Motorola, Inc

  MC14497 Datasheet HTML 1Page - Motorola, Inc MC14497 Datasheet HTML 2Page - Motorola, Inc MC14497 Datasheet HTML 3Page - Motorola, Inc MC14497 Datasheet HTML 4Page - Motorola, Inc MC14497 Datasheet HTML 5Page - Motorola, Inc MC14497 Datasheet HTML 6Page - Motorola, Inc MC14497 Datasheet HTML 7Page - Motorola, Inc MC14497 Datasheet HTML 8Page - Motorola, Inc  
Zoom Inzoom in Zoom Outzoom out
 3 / 8 page
background image
MC14497
MOTOROLA
3
CIRCUIT OPERATION
The transmitter sends a 6–bit, labelled A (LSB) to F (MSB),
binary code giving a total of 64 possible combinations or
code words. All of these channels are user selectable, ex-
cept the last two (where channel 63 is not sent while channel
62 is automatically sent by the transmitter at the end of each
transmission as an “End of Transmission” code).
In either mode, FSK or AM, the transmitted signal is in the
form of a bi–phase pulse code modulation (PCM) signal. The
AM coding is shown in Figure 1.
BIT–n
f1
f1
“0”
“1”
Figure 1. AM Coding
AM
In the AM mode, f1 is a train of pulses at the modulating
frequency of 31.25 kHz for a reference frequency of 500 kHz.
In the FSK mode, two modulating frequencies are used as
shown in Figure 2.
BIT–n
f2
f3
“0”
“1”
Figure 2. FSK Coding
f2
f3
FSK
In this mode, f3 is 50 kHz and f2 is 41.66 kHz for a refer-
ence frequency of 500 kHz.
The keyboard can be a simple switch matrix using no ex-
ternal diodes, connected to the four scanner inputs (A1 – A4)
and the eight row input (E1 – E8). Under these conditions,
only the first 32 code words are available since bit–F is al-
ways at logical 0. However, a simple 2–pole changeover
switch, in the manner of a typewriter “shift” key (switch FK3 in
the Block Diagram) can be used to change the polarity of
bit–F to give access to the next full set of 32 instructions.
An alternative method of accessing more than 32 instruc-
tions is by the use of external diodes between the address
inputs (see Figure 3). These have the effect of producing
“phantom” address inputs by pulling two inputs low at the
same time, which causes bit–F to go high (i.e., to logical 1).
By interconnecting only certain address inputs it is possible
to make an intermediate keyboard with between 32 and 64
keys.
The other two switches in the Block Diagram (FK1 and
FK2) change the modulation mode. Closing FK1 changes
the modulation from FSK to AM and the start–bit polarity.
Closing FK2 changes the start–bit to a logical 0.
The full range of options available is illustrated in Table 1.
Table 1.
Start
Bit
Modulation
Bit–F
Channels
E9 = Open
1
FSK
0
0 – 31
E9 = A1 (FK1)
1
AM
0
0 – 31
E9 = A2 (FK2)
0
FSK
0
0 – 31
*
E9 = A3 (FK3)
1
FSK
1
32 – 61
E9 = A1
A2
0
AM
0
0 – 31
E9 = A1
A3
1
AM
1
32 – 61
E9 = A2
A3
0
FSK
1
32 – 61
*
E9 = A1
A2 A3
0
AM
1
32 – 61
* Not allowed.
One of the transmitter’s major features is its low power
consumption (in the order of 10
µA in the idle state). For this
reason, the battery is perpetually in circuit. It has in fact been
found that a light discharge current is beneficial to battery
life.
In its active state, the transmitter efficiency is increased by
the use of a low duty cycle which is less than 2.5% for the
modulating pulse trains.
While no key is pressed, the circuit is in its idle state and
the reference oscillator is stopped. Also, the eight address in-
put lines are held high through internal pull–up resistors.
As soon as a key is pressed, this takes the appropriate ad-
dress line low, signaling to the circuit that a key has been se-
lected. The oscillator is now enabled. If the key is released
before the code word has been sent, the circuit returns to its
idle state. To account for accidental activation of the transmit-
ter, the circuit has a built–in reactive time of approximately
20 ms, which also overcomes contact bounce. After this
delay, the code word will be sent and repeated at 90 ms inter-
vals for as long as the key is pressed. As soon as the key is
released, the circuit automatically sends channel 62, the
“End of Transmission” (EOT) code. The transmitter then re-
turns to its idle state.
The differences between the two modulation modes are il-
lustrated in Figure 4. However, it should be noted that in the
AM mode, each transmitted word is preceded by a burst of
pulses lasting 512
µs. This is used to set up the AGC loop in
the receiver’s preamp. In the FSK mode, the first frequency
of the first bit is extended by 1.5 ms and the AGC burst is
suppressed. In either mode, it is assumed that the normal
start–bit is present.


Số phần tương tự - MC14497

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
ON Semiconductor
MC14490 ONSEMI-MC14490 Datasheet
234Kb / 12P
   Hex Contact Bounce Eliminator
May, 2000 ??Rev. 4
MC14490 ONSEMI-MC14490 Datasheet
126Kb / 11P
   Hex Contact Bounce Eliminator
June, 2006 ??Rev. 7
MC14490DW ONSEMI-MC14490DW Datasheet
234Kb / 12P
   Hex Contact Bounce Eliminator
May, 2000 ??Rev. 4
MC14490DW ONSEMI-MC14490DW Datasheet
126Kb / 11P
   Hex Contact Bounce Eliminator
June, 2006 ??Rev. 7
MC14490DWG ONSEMI-MC14490DWG Datasheet
126Kb / 11P
   Hex Contact Bounce Eliminator
June, 2006 ??Rev. 7
More results

Mô tả tương tự - MC14497

nhà sản xuấttên linh kiệnbảng dữ liệuGiải thích chi tiết về linh kiện
logo
STMicroelectronics
M708 STMICROELECTRONICS-M708 Datasheet
345Kb / 9P
   PCM REMOTE CONTROL TRANSMITTER
logo
Motorola, Inc
MC14422 MOTOROLA-MC14422 Datasheet
220Kb / 6P
   REMOTE CONTROL TRANSMITTER
logo
Princeton Technology Co...
PT2462 PTC-PT2462_10 Datasheet
448Kb / 12P
   Remote Control Transmitter
logo
NXP Semiconductors
SAA3004 PHILIPS-SAA3004 Datasheet
103Kb / 16P
   Remote control transmitter
August 1982
logo
Zarlink Semiconductor I...
MV500 ZARLINK-MV500 Datasheet
357Kb / 4P
   REMOTE CONTROL TRANSMITTER
logo
List of Unclassifed Man...
SL490B ETC-SL490B Datasheet
136Kb / 5P
   REMOTE CONTROL TRANSMITTER
logo
Princeton Technology Co...
PT2243 PTC-PT2243 Datasheet
344Kb / 3P
   Remote Control Transmitter
logo
STMicroelectronics
M3004LAB1 STMICROELECTRONICS-M3004LAB1 Datasheet
105Kb / 10P
   REMOTE CONTROL TRANSMITTER
M3005LAB1 STMICROELECTRONICS-M3005LAB1 Datasheet
101Kb / 10P
   REMOTE CONTROL TRANSMITTER
M3004LD STMICROELECTRONICS-M3004LD Datasheet
336Kb / 14P
   REMOTE CONTROL TRANSMITTER
More results


Html Pages

1 2 3 4 5 6 7 8


bảng dữ liệu tải về

Go To PDF Page


Link URL




Chính sách bảo mật
ALLDATASHEET.VN
Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com