ST7LNB0

9/22

6.2 ABSOLUTE MAXIMUM RATINGS

Stresses above those listed as “absolute maxi-

mum ratings” may cause permanent damage to

the device. This is a stress rating only and func-

tional operation of the device under these condi-

tions is not implied. Exposure to maximum rating

conditions for extended periods may affect device

reliability.

6.2.1 Voltage Characteristics

6.2.2 Current Characteristics

6.2.3 Thermal Characteristics

Notes:

tion occurs (for example, due to a corrupted program counter). To guarantee safe operation, this connection has to be

done through a pull-up or pull-down resistor (typical: 10k

Ω for I/Os). Unused I/O pins must be tied in the same way to V

DD

4. Negative injection disturbs the analog performance of the device. In particular, it induces leakage currents throughout

the device including the analog inputs. To avoid undesirable effects on the analog functions, care must be taken:

- Analog input pins must have a negative injection less than 0.8 mA (assuming that the impedance of the analog voltage

is lower than the specified limits)

- Pure digital pins must have a negative injection less than 1.6mA. In addition, it is recommended to inject the current as

far as possible from the analog input pins.

5. When several inputs are submitted to a current injection, the maximum

ΣI

and negative injected currents (instantaneous values). These results are based on characterisation with

ΣI

mum current injection on four I/O port pins of the device.

6. True open drain I/O port pins do not accept positive injection.

Symbol

Ratings

Maximum value

Unit

Supply voltage

7.0

V

Electrostatic discharge voltage (Human Body Model)

see section 6.5.3 on page 13

Electrostatic discharge voltage (Machine Model)

Symbol

Ratings

Maximum value

Unit

3)

100

mA

3)

100

Output current sunk by any standard I/O and control pin

25

Output current sunk by any high sink I/O pin

50

Output current source by any I/Os and control pin

- 25

2) & 4)

Injected current on RESET pin

± 5

± 5

ΣI

INJ(PIN)

2)

± 20

Symbol

Ratings

Value

Unit

Storage temperature range

-65 to +150

°C

Maximum junction temperature (see Section 7.2 THERMAL CHARACTERISTICS)